Search Results
Showing results for terminal
Hardwiring your battery-powered Ring doorbell
...using the included wire nuts. Using Plug-In Adapter Insert the plug-in adapter connectors underneath the terminal screws on the rear of your doorbell, then tighten the terminals to secure. Step 6: Mounting the doorbell Feed any excess wiring and wire nuts back into the wall, then secure...
Installing Wired Video Doorbell Pro (3rd Gen)
...transformer from its housing unit. 8. Connect power to the bottom L & N terminals and the doorbell to positive & negative terminals (doorbell wires can go in either terminal). 9. (Optional) If using a corner mount, install the mount over your doorbell wires using the bottom holes in the top and...
Enclosure for Ring DIN Rail Transformer
...Pass the cables through the holes. Mount the back enclosure on the wall. Connect power to the bottom L & N terminals and the doorbell to + & - (doorbell wires can go in either terminal). Note: If you are using a third-party transformer, you should refer to manufacturers instructions. Install...
Installing DIN Rail Transformer (2nd Gen and 3rd Gen)
...7. Install the included transformer. 8. Connect power to the bottom L & N terminals and the doorbell to positive & negative terminals (doorbell wires can go in either terminal). 9. Refer to your doorbell setup guide to complete setup...
Installing Intercom Kit for Video Doorbells
...toimitetuilla ruuveilla. / Montér med de medfølgende skruer. / اعمد إلى التركيب باستخدام البراغي المزودة. 6. Attach doorbell gasket around wire terminal, if necessary. / Fixez le joint d’étanchéité de la sonnette autour de la borne du fil, si nécessaire. / Bringen Sie die Dichtung der Türklingel...
Safety and compliance information for Ring Quick Release Battery Pack
...Only use the battery in Ring devices. Do not short-circuit a battery or allow metallic conductive objects to come into contact with battery terminals. Avoid dropping the battery. If the battery is dropped, especially on a hard surface, and the user suspects damage, do not attempt repair...
Configuring and troubleshooting your in-home chime
...screwdriver to both terminal screws at the same time, or touch the doorbell wires together. Do not perform this test if you have bypassed the in-home chime or hardwired directly to a transformer. If wired correctly, you will hear your in-home chime when the two screw terminals are bridged...
The difference between the Pro Power Cable and Pro Power Kit v2 (for Ring Video Doorbell Pro)
...Loosen the terminal screw for the wire labeled Front. Open the orange lever on the wire clip and insert the wire, snapping the orange lever down to lock it in place...
Installing Wired Video Doorbell Pro (3rd Gen) Plug-In
...the removal tool into the slot at the bottom of your doorbell. 7. Connect the power cable to your doorbell’s wire terminals. NOTE: You can attach any wire to any terminal. 8. Mount your doorbell by hooking it over the bracket and pushing down. 9. Tighten the security screw. 10. Plug in the...
Safety and Compliance Information for Outdoor Cam Plus
...or other hazards. To avoid short-circuiting a battery, do not allow battery terminals to touch metallic conductive objects or other battery terminals. Avoid dropping the device or battery. Do not crush or puncture the battery...