Installing Indoor Cam 4K

Safety and compliance information for Ring Indoor Cam 4K

Hardware included

Tools needed

Phillips-head screwdriver

Drill with 3/16 in (5 mm) masonry bit (optional)

1. Download the Ring Always Home app.

2. Scan the QR code on your device.

3. Choose a location.

On a table or shelf

1. Connect the included cable to your camera, then plug it into an outlet.

2. Plug the power supply into an outlet and wait for your camera to turn on.

3. (Optional) To point the camera upward, turn the base 180° for better balance.

On a wall

1. Remove the mounting plate from the base by pushing the plate in the direction of the arrow.

2. Hold the mounting plate against the surface, and mark screw holes. On stucco, brick, or concrete, use a 3/16 in (5 mm) masonry bit to drill holes for the included wall anchors.

3. Install the mounting plate with the UP arrow pointing up.

On stucco, brick, or concrete, use a 3/16 in (5 mm) masonry bit to drill holes for the included wall anchors.

4. Connect the included cable to the port on the back of your camera.

5. Swivel the base toward the back of your camera.

6. Slot your camera onto its mounting plate.

7. Anchor the power cable to the wall with a cable clip.

8. Plug the power supply into an outlet and wait for your camera to turn on.

On a ceiling

1. Remove the mounting plate from the base by pushing the plate in the direction of the arrow.

2. Hold the mounting plate against the surface, and mark screw holes. On stucco, brick, or concrete, use a 3/16 in (5 mm) masonry bit to drill holes for the included wall anchors.

3. Install the mounting plate with the UP arrow pointing toward your desired viewing direction.

On stucco, brick, or concrete, use a 3/16 in (5 mm) masonry bit to drill holes for the included wall anchors.

4. Connect the included cable to the port on the back of your camera.

5. Slot your camera onto its mounting plate.

6. Anchor the power cable to the wall or ceiling with a cable clip.

7. Plug the power supply into an outlet and wait for your camera to turn on.

Attaching the lens cover

1. Insert the peg into the notch at the bottom of your camera.

2. Push until you hear a click to secure.

Using the lens cover

1. To cover your camera, slide the lens cover to the locked position until you hear a click.

2. To uncover your camera, slide the lens cover to the unlocked position until you hear a click.

Removing the lens cover

1. Slide the lens cover to the unlocked position.

2. Lift the top edge of the lens cover to detach it from the camera.

3. Detach the peg from the bottom to remove.