Installing your Solar Charger (2nd Gen) for Battery Doorbells

Installing your Solar Charger (2nd Gen) for Battery Doorbells is a very simple process. Scroll down for a step-by-step guide.

1. Uninstall your Ring Video Doorbell 3, 3 Plus, 4, Ring Battery Video Doorbell Plus or Ring Battery Video Doorbell Pro
If your Ring Video Doorbell 3, 3 Plus, 4 or Ring Battery Video Doorbell Plus has already been installed, you'll need to uninstall it before putting up your Solar Charger. To uninstall the Ring Video Doorbell:
* Remove the security screw.
* Pop off the faceplate.
* Remove the mounting screws.
Image-02_preview.jpeg
2. Mount the Solar Charger
Using the provided screws mount your new Solar Charger to the wall.
Note:
If you are mounting the Solar Charger to a brick or stucco wall, you will need to use the provided wall anchors.
Image-03_preview.jpeg
3. Connect your Ring Video Doorbell 3, 3 Plus, 4 or Ring Battery Video Doorbell Plus
In the next step, you will need to connect your doorbell to the Solar Charger.
* Loosen the two screw terminals on the back of your doorbell
* Insert the wire connector from the Solar Charger under the screws on the terminal.
*
Note:
Be sure that the side of the terminal that reads "Up" is facing you when you connect the Solar Charger to the screw terminals.
* Re-tighten the screws on the terminals.
Image-04_preview.jpeg
4. Put your Ring Video Doorbell 3, 3 Plus, 4 or Ring Battery Video Doorbell Plus on the Solar Charger
In the next step, you'll need to fit your doorbell into the recessed portion of the Solar Charger.
*
Note:
Be sure to feed the retractable wire wire back into the charger.
Once your doorbell has been fitted into the Solar Charger, secure it using the provided bolts.
Image-05_preview.jpeg
5. Finish your installation
Finish your installation by re-attaching the faceplate to your doorbell and installing the security screw.
Image-06_preview.jpeg

Last updated 5 months ago