How to physically install your Ring Video Doorbell 3 Plus without an existing doorbell

Physically installing up your Ring Video Doorbell 3 Plus without an existing doorbell is a simple process. Simply scroll down for a step-by-step guide.  

Note that you should setup your Ring Video Doorbell 3 Plus in your Ring app before mounting it to your door.

Click here for information on setting up your Ring Video Doorbell in the Ring app. 

1. Charge the provided battery

  • Fully charge the battery by plugging it into a power source using the provided orange cable.
  • The small light on top will glow green when fully charged. 
  • Insert the battery into the bottom of your Ring Video Doorbell 3 Plus until it clicks into place.

2. Line up your Ring Video Doorbell 3 Pus 

To properly line up your Ring Video Doorbell 3 Plus: 

  • Click the level tool (included in the box) into the small hole on the front of the Ring Video Doorbell 3 Plus below the camera.
  • Place the Ring Video Doorbell 3 Plus next to your door at about 48 inches from the ground. 
  • Level the device using the level tool. 
  • Mark the positions for mounting holes with a pencil. 

3. Drill holes

Optional: Use a drill to drill holes where you marked the position of the mounting holes.

  • If you are mounting the Ring Video Doorbell 3 Plus on brick, concrete, or stucco, put the included plastic anchors into the holes. You may need to use a hammer to get the anchors in. 
  • If you are using the included optional adaptor mounting plate on wood or vinyl, just use the included screws.  

4. Place Your Ring Video Doorbell 3 Plus over the holes

Don't forget to remove the level tool from the front of the device. 

5. Screw in Ring Video Doorbell 3 Plus

Feed all the wires (and the wire nuts if you used them) into your wall and secure your Ring Video Doorbell 3 Plus on the wall. Be sure you use all four included screws. 

6. Install the faceplate

Place one of the provided faceplates on your Ring Video Doorbell by slotting it in at the top and clicking it into place.

7. Tighten the security screw

Use one of the provided security screws and the star-shaped end of the screwdriver bit to secure the faceplate.

Click here for information on setting up your Ring Video Doorbell 3 Plus in your Ring app.

Last updated 9 months ago