Safety and Compliance Information for Ring Pan-Tilt Indoor Cam

IMPORTANT PRODUCT INFORMATION

SAFETY INFORMATION

READ ALL SAFETY INFORMATION BEFORE USING THE DEVICE.

FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS COULD RESULT IN FIRE, ELECTRIC SHOCK, OR OTHER INJURY OR DAMAGE.

Your device does not have an on/off button. If you wish to stop power from flowing into your device, unplug the power cord. Do not plug multiple electric devices into the same wall socket. Overloading a socket can cause it to overheat and may result in a fire.

Your device is shipped with an AC adapter 5F94F2. Your device should only be powered using the AC adapter included with the device. If the adapter or cable appears damaged, discontinue use immediately. Install your power adapter into an easily accessible socket-outlet located near the equipment that will be plugged into or powered by the adapter.

Do not expose your device or adapter to liquids. If your device or adapter gets wet, carefully unplug all cables without getting your hands wet and wait for the device and adapter to dry completely before plugging them in again. Do not attempt to dry your device or adapter with an external heat source, such as a microwave oven or a hair dryer. If the device or adapter appear damaged, discontinue use immediately. Use only accessories supplied with the device to power your device.

Install your power adapter into an easily accessible electrical socket located near the equipment that will be plugged into or powered by the adapter.

OTHER SAFETY CONSIDERATIONS

Use only accessories supplied with your device, or specifically marketed for use with your device, to power your device. Use of third-party accessories may impact your device’s performance. In limited circumstances, use of third-party accessories may void your device’s limited warranty. In addition, use of incompatible third-party accessories may cause damage to your device or the third-party accessory. Read all safety instructions for any accessories before using with your device.

Don’t expose your device to steam, extreme heat or cold. For example, do not install your device near any heat sources such as space heaters, heater vents, radiators, stoves, or other things that produce heat. Use your device in a location where temperatures remain within the device’s operating temperature range set forth in this guide. Your device may get warm during normal use. To reduce the effect of the warming, place your device on a heat-resistant surface.

WARNING: Small parts contained in your device and its accessories may present a choking hazard to small children.

Pan-Tilt Indoor Cam and its accessories are for indoor use only.

CAUTION: When mounting this device in elevated locations, use precautions to ensure that the device does not fall and harm bystanders. Only handle your device with clean hands. Clean the Device by unplugging it and using a soft cloth that is slightly damp with water and a touch of rubbing alcohol; be careful not to wipe it with anything abrasive or to use any harsh chemicals. After cleaning, wait for the Device to dry completely before plugging it in again.

PRODUCT SPECIFICATIONS

Model number: 5F93F2

Electrical rating: 5V2A

Operating Temperature Range: -4°F to 113°F (-20°C to 45°C)

FOR USA CUSTOMERS

Supplier’s Declaration of Conformity

Device Name: Ring Pan-Tilt Indoor Cam

Model: 5F93F2

FCC Compliance: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

Responsible Party and Party issuing Supplier’s Declaration of Conformity: Ring LLC, 12515 Cerise Ave Hawthorne, CA, 90250 U.S.A. www.ring.com / legal@ring.com

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution, pursuant to Section 15.21 of the FCC rules, user changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with FCC radio frequency radiation exposure limits set forth for an uncontrolled environment. Information is on file with the FCC and can be found by inputting such Product’s FCC ID (which can be found on the device) into the FCC ID Search form available at fcc.gov/oet/ea/fccid. The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other product antenna or transmitter.

FOR CANADIAN CUSTOMERS

Innovation, Science and Economic Development Canada (ISED) Compliance

This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.

Information Regarding Exposure to Radio Frequency Energy

This equipment complies with IC RSS-102 RF exposure limits set forth for an uncontrolled environment.

This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body.

CAN ICES-3(B)

FOR MEXICO CUSTOMERS

The operation of this equipment is subject to these two conditions: (1) this equipment or device may not cause harmful interference and (2) this equipment or device must accept any interference, including interference that may cause undesired operation.

RECYCLING YOUR DEVICE PROPERLY

In some areas, the disposal of certain electronic devices is regulated. Make sure you dispose of, or recycle, your device in accordance with your local laws and regulations. For information about recycling your device, go to www.amazon.com/devicesupport.

ADDITIONAL SAFETY AND COMPLIANCE INFORMATION

Additional safety, compliance, recycling and other important information regarding your device can be found at: www.ring.com/legal

TERMS AND POLICIES

By purchasing or using the product, you agree to the Terms of Service found at ring.com/terms. For other applicable policies, visit ring.com/legal.

LIMITED WARRANTY For information on the Limited Warranty, visit ring.com/legal