Search Results for Ring Help
Showing results for mount
Solar Panel for Spotlight Cam (1st Gen) Information
...Panel. Drill a hole for the anchors using the provided drill bit. Insert the anchors. Use the screws to secure the mount. How do I aim the Solar Panel? The adjustable mounting arm allows you to aim the Solar Panel in the best possible direction to catch the sun...
Solar Panels for battery doorbells
...branches or the shadows of nearby objects that may block the sun. Installing your Solar Panel You can mount the Solar Panel directly into wood using the provided screws. If you are mounting to brick, concrete or stucco: Mark the holes where you wish to mount the Solar Panel. Drill holes for the...
Installing Spotlight Cam (1st Gen) for Battery, Solar, and Wired
...plate Press the rear button to open the battery compartment. Remove the screw and weather seal. Press the release button and slide out the mounting plate. Insert the plate in the desired direction. Tighten the security screw. Place the weather seal in the unused hole. For wall mounting: The...
Set up and install Ring Intercom Audio or Ring Intercom Video
...on your intercom on the wall. Step 4: Mount your Intercom Mount your Ring Intercom device to the wall beside your handset using double-sided tape or screws. For mounting location, make sure you're close enough to connect the cable. Tape mount (for smooth walls): Your device comes with strong tape on...
Ring Alarm (2nd Gen) Installation Guide
...Green means the test is successful. Red means the test failed. Mounting Hold the mounting bracket at the mounting location and level it using the spirit level. Mark your holes using the mounting bracket as a guide. Drill holes using a 6mm...
Adhesive installation instructions for Ring Alarm Sensors
...and bond strength. Following the below guidelines will ensure reliable adhesion and long-lasting results. Important note : If your desired mounting surface is a hard to clean area like wood, adhesive strips may not be the most appropriate mounting solution. When mounting a sensor to a wood...
Installing Wired Doorbell Pro
...when securing your Ring Doorbell. 1213 Mount your Ring Doorbell to the Corner Mount. Secure your Ring Doorbell to the Corner Mount with the two included short mounting screws. Be sure to feed any excess wiring back into the wall first. If you used the wire nuts, push them through the hole as...
Installing Ring Retrofit Alarm Kit
...Retrofit Alarm Kit. The Retrofit Alarm Kit should be mounted near the wired alarm panel box, but not inside it. We recommend mounting it on the wall next to the wired alarm panel. Do not mount near combustible or flammable surfaces. 3. Mount the Retrofit Alarm Kit. We suggest that you use the...
Installing Access Controller Pro 2
...hole to mount the puck antenna as well as a ~3/8" (9 mm) hole for the wiring. Mount the Ring Access Controller Pro 2 inside the enclosure using the provided mounting strips. For external junction box installations, mount the junction box in a location that minimizes moisture intrusion...
Installing lens cover for Outdoor Cam Pro
...5. Tighten the screw into the top hole on the back of your camera to secure. 6. Attach the mount to the bottom of your camera with its screw. 7. Reattach the mounting plate by sliding until you hear a click to secure. Lens Cover for Outdoor Cam Pro | 3EN Wall installation FOR...