Safety and compliance information for Ring Bridge (2nd Gen)
IMPORTANT PRODUCT INFORMATION
SAFETY INFORMATION
READ ALL SAFETY INFORMATION BEFORE USING THE DEVICE. FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS COULD RESULT IN FIRE, ELECTRIC SHOCK, OR OTHER INJURY OR DAMAGE.
When this device is plugged into an electrical socket, unplugging the device will disconnect it from the AC mains supply. Only plug this device into an easily accessible electrical socket.
Your device does not have an on/off button. If you wish to stop power from flowing into your device, unplug the device. Do not plug multiple electric devices into the same wall socket. Overloading a socket can cause it to overheat and may result in a fire.
Do not expose your device to liquids. If your device gets wet, carefully unplug all cables without getting your hands wet and wait for the device to dry completely before plugging them in again. Do not attempt to dry your device with an external heat source, such as a microwave oven or a hair dryer. If the device appear damaged, discontinue use immediately.
OTHER SAFETY CONSIDERATIONS
Use only accessories supplied with your device, or specifically marketed for use with your device, to power your device. Use of third-party accessories may impact your device’s performance. In limited circumstances, use of third-party accessories may void your device’s limited warranty. In addition, use of incompatible third-party accessories may cause damage to your device or the third-party accessory. Read all safety instructions for any accessories before using with your device.
Don’t expose your device to steam, extreme heat or cold. Use your device in a location where temperatures remain within the device’s operating temperature range set forth in this guide. Your device may get warm during normal use.
Use this device in dry rooms only. Do not cover the device while operating. Do not open the housing. Protect this device from sunlight. Disconnecting the plug will power the device off. Do not use the device if the plug or housing is defective, there is a risk of electric shock.
This device is only suitable for mounting at heights ≤ 2 m.
PRODUCT SPECIFICATIONS
Ring Bridge (2nd Gen)
Model number: 7RCEAB
Electrical rating: 100–240 V ~ 50/60 Hz, 25 W
Operating Temperature Range: 32°F to 104°F (0°C to 40°C)
FOR USA CUSTOMERS
Supplier’s Declaration of Conformity
Device Name: Ring Bridge (2nd Gen)
Model: 7RCEAB
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Responsible Party and Party issuing Supplier’s Declaration of Conformity:
Ring LLC, 12515 Cerise Ave Hawthorne, CA, 90250 U.S.A.
www.ring.com / legal@ring.com
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution, pursuant to Section 15.21 of the FCC rules, user changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with FCC radio frequency radiation exposure limits set forth for an uncontrolled environment. Information is on file with the FCC and can be found by inputting such Product’s FCC ID (which can be found on the device) into the FCC ID Search form available at fcc.gov/oet/ea/fccid.
The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other product antenna or transmitter.
RECYCLING YOUR DEVICE PROPERLY
In some areas, the disposal of certain electronic devices is regulated. Make sure you dispose of, or recycle, your device in accordance with your local laws and regulations. For information about recycling your device, go to www.amazon.com/devicesupport.
ADDITIONAL SAFETY AND COMPLIANCE INFORMATION
Additional safety, compliance, recycling and other important information regarding your device can be found at: www.ring.com/legal
TERMS AND POLICIES
By purchasing or using the product, you agree to the Terms of Service found at ring.com/terms. For other applicable policies, visit ring.com/legal.
LIMITED WARRANTY
For information on the Limited Warranty, visit ring.com/legal.