Learning Light Patterns for Wired Doorbell Plus
The LED light on the front of your Ring Wired Doorbell Plus indicates the status of your unit. A solid white light means it's either in idle mode or recording.
Additional descriptions of light patterns are shown below:
Flashing Light Pattern | Activity |
LEDs around the button spin blue | Ordinary button press |
LEDs around the button spin white | Attempting to set up wifi when the device doesn't have any saved wifi credentials. Times out after 10 minutes. |
Blue light moving upwards | In the process of connecting to network during setup |
White light flashing on and off | Firmware update in progress |
Blue circle is flashing, one second on, one second off | Device is booting up |
Solid blue light | The speaker has been enabled |
LEDs flash four times | Successful set up. Note: It can take up to an hour for Ring Wired Doorbell Plus to fully power on upon first installation. |
Flashing white light at the top of the circle | Setup failed - password error |
Flashing white light at the right of the circle | Setup failed - couldn't connect to selected wifi network |
Flashing white light at the left of the circle | Setup failed - another reason |
Short rapid flashing burst of blue light, followed by a spinning white circle | Factory restore |
Top half blue flashing | During setup - bad password / after connection to power - device is charging |
Bottom half red flashing | Device is not receiving enough power |
Last updated 2 months ago