Installing PoE+ to USB-C Adapter

Hardware included

Tools needed

Phillips-head screwdriver

Drill with a 3/16 in (5 mm) masonry bit (optional)

Before you begin

1.

Choose a location.

NOTE: Before installation, ensure your Power over Ethernet (PoE) switch capable of PoE+ is active and connected to a functioning Category 5 or above Ethernet cable.

Free-standing installation (FOR INDOOR USE ONLY)

1.

Plug the Ethernet cable into the adapter.

2.

If connecting to Indoor Cam 4K, plug the included L-shaped USB-C cable into your camera.

NOTE: If connecting to another Ring camera, plug the included flat USB-C cable into your camera until the indicator line disappears.

3.

Plug the other end of the USB-C cable into the adapter until the indicator line disappears.

NOTE: Secure the adapter to the ground, wall, table, or other stationary surface to prevent tripping hazards. Avoid hanging the adapter in the air. Position the cord away from walkways when possible.

Mounting installation (FOR INDOOR USE ONLY)

1.

Install the adapter on the wall with the included screws.

On stucco, brick, or concrete, use a 3/16 in (5 mm) masonry bit to drill holes for the included wall anchors.

2.

Plug the Ethernet cable into the adapter.

3.

If connecting to Indoor Cam 4K, plug the included L-shaped USB-C cable into your camera.

NOTE: If connecting to another Ring camera, plug the included flat USB-C cable into your camera until the indicator line disappears.

4.

Plug the other end of the USB-C cable into the adapter until the indicator line disappears.