Setting Up Your Dome Siren in the Ring App

Setting up your Dome Siren in the Ring App is a very simple process. Scroll down for a step-by-step guide.

Before You Start

If there is an update available for your Ring App, please update it before you begin. Remind any shared users to update their app too. Updating the app ensures that everyone on your account will be able to see this new device.

Step One - Select Set Up a Device

Open the side menu by tapping the three parallel lines in the upper left-hand side of the screen.

1. Open the Ring app to the main dashboard.

2. Scroll down to the bottom and tap

   Set Up a Device

   .
3. Tap

   Security

   .
4. Tap

   Sirens

   .
5. Tap

   Z-Wave Indoor Siren

   .
6. Tap

   Ready

   .

Step Two - Open the back cover of the Dome Siren

Open the back cover of the Dome Siren by twisting the back cover into an unlock position and pry the cover off the siren. When the cover is off, tap Next on the app. 

Step Three - Pull out the clear tab on the back of the Dome Siren

Remove the battery tab located at the end of one of the batteries. This turns the siren on. Tap the Add button and your Alarm or Alarm Pro Base Station should find the Siren automatically.

Note: Do not remove the tab the middle of the batteries. The correct tab says in very small letters "Remove before use."

Note: If the siren does not pair successfully, try the pairing process again. Start by following the in-app instructions. When it’s time to pull the battery tab, simply remove and reinsert your battery to complete this process.   

Step Four - Rename your Dome Siren

After your Dome Siren is added to the system, you will tap the Done button. Next you will see the Device Configuration screen.

To make no changes, tap the Done button.

To add your Dome Siren to a room, or change the name to something else, tap the Dome Siren.

On the Device Profile screen, you can tap Name and Room to customize the siren.

• Tap

  Name

  , and enter your own name for the Dome Siren and tap

  Save

  .
• Tap

  Room

   to specify which room will have this Dome Siren, and tap

  Save

   in the upper right corner.

Note: You can select a room from the list, or add your own room name by tapping Add Room.

When you’ve finished setting up the Dome Siren, select the back arrow to return to the Device Configuration screen, and then tap Done.