Installing Your Ring Video Doorbell 3 and 3 Plus Solar Charger
1. Uninstall your Ring Video Doorbell 3 or 3 Plus. If your Ring Video Doorbell 3 or 3 Plus has already been installed, you'll need to uninstall it before putting up your Solar Charger. To uninstall: 1. Remove the security screw. 2. Pop off the faceplate. 3. Remove the mounting screws. | |
2. Mount the Solar Charger. Using the provided screws mount your new Solar Charger to the wall. * If you are mounting the Solar Charger to a brick or stucco wall, you will need to use the provided wall anchors. | |
3. Connect your Ring Video Doorbell 3 or 3 Plus. Connect your Ring Video Doorbell 3 or 3 Plus to the Solar Charger. 1. Loosen the two screw terminals on the back of your Ring Video Doorbell 3 or 3 Plus. 2. Insert the wire connector from the Solar Charger under the screws on the terminal. * Be sure that the side of the terminal that reads "Up" is facing you when you connect the Solar Charger to the screw terminals. 3. Re-tighten the screws on the terminals. | |
4. Put your Ring Video Doorbell 3 or 3 Plus on the Solar Charger. Fit your Ring Video Doorbell into the recessed portion of the Solar Charger. Note: Be sure to feed the retractable wire back into the charger. Once your Ring Video Doorbell 3 or 3 Plus has been fitted into the Solar Charger, secure it using the provided bolts. | |
5. Finish your installation. Finish your installation by re-attaching the faceplate to your Ring Video Doorbell 3 or 3 Plus and installing the security screw. |
Note: When the battery is over 90% charged, it will no longer accept a new charge. But below 90%, it will charge from the solar panel.
Tap for more information on the Ring Video Doorbell 3 or 3 Plus Solar Charger.
Last updated 8 months ago