How to Physically Install your Wired Doorbell Plus

Install your Wired Doorbell Plus by watching this video or following the step-by-step instructions.

How to set up your Wired Doorbell Plus in the Ring app

Remove your existing doorbell button

1. Turn off power at the

   breaker

   .
2. Remove the button on your

   existing doorbell

   and disconnect the wires.

Install your Pro Power Kit 

If you have an existing Pro Power Kit already installed, you must use the new one included with your new doorbell.

1. Remove the cover to your

   in-home doorbell chime kit

   . 
2. Verify that it is

   compatible

   with the Ring Wired Doorbell Plus by

   following these steps.
3. If your chime kit isn’t compatible,

   tap here to learn how to bypass it.
4. Verify your transformer has an output of

   16-24V AC and 30VA

   and

   50/60 Hz.
   • If it doesn't, you can

     get a replacement transformer

     and 

     follow these steps

      to install it.
   • Alternatively, you can

     get a plug-in adapter

     to power your doorbell with an outlet.

     Tap here to learn how to install the adapter.
   • Note:

     Do not use a halogen or garden-lighting transformer or a DC transformer/power supply.
5. Install your Pro Power Kit or Pro Power Cable (pictured below). Scroll down to the link that applies to you and follow the steps on that page.

• Learn how to install the Pro Power Kit

  .

• Learn how to install the Pro Power Kit V2

  .

• Learn how to install the Pro Power Cable

  .

Mount your Ring Wired Doorbell Plus

1. If necessary, remove the security screw from the faceplate.
2. Remove the faceplate: Grasp the edges of the faceplate and push gently against the front of the Doorbell to remove.
3. If mounting on a masonry surface, place your Wired Doorbell Plus where you want to mount it and

   mark pilot holes

   . Then, drill holes where you've marked the holes and

   insert the anchors

   .
4. Connect the wires to the screws

   on the back of the device.
   • It doesn't matter which order the wires are connected.
   • Be sure the wires don't touch each other.
   • Be careful of over-tightening these screws as well.
5. Place the device against the wall

   . Make sure that it is level, then drive the screws in.
   • Wired Doorbell Plus will

     never

     require a diode to be installed.
6. Turn the power back on at the breaker.

Set up the doorbell in the Ring app

1. Double check each portion of your wiring

   and then turn the power back on. The device will require up to an hour to charge its internal power cell. After it has been charged, the device will automatically move into setup mode.
2. Now that the device has been installed,

   set it up in the Ring app

   .

Attach the faceplate

1. Place the faceplate

   on the doorbell and ensure it is secured to the device.
2. Install the security screw

   at the bottom of the device.