Ring Stick Up Cam (2nd Generation) placed on a desk watching over an office

How to Install Stick Up Cam Battery (2nd Gen) With the Ceiling Mount

Get a bird’s eye view of your home by installing your Stick Up Cam Battery on the ceiling with this step-by-step guide.

Step One - Charge the provided battery

Fully charge the provided battery using a USB power source and the orange cable until the battery’s LED light is green.

Step Two - Remove the battery cover

Twist the battery cover counterclockwise to unlock, then remove it from your Stick Up Cam.

Step Three - Choose a location

Choose the spot where Stick Up Cam can provide the view you want.

Step Four - Remove the base

Unscrew the base using a standard Philips-head screwdriver.

Step Five - Attach the Stick Up Cam Mount

Attach the smaller end of the Stick Up Cam Mount to the rear of the Stick Up Cam. Screw it into place using the large silver screw that comes in your Stick Up Cam Mount packaging.

Step Six - Attach the rubber pad

Be sure that the white rubber pad is attached to the base of the Stick Up Cam Mount. Otherwise attach it by pushing the rubber pad into the base of the mount.

Step Seven - Swivel the stand

Once you've attached the mount to the back of your Stick Up Cam, swivel the mount so that the base is above the camera.

Step Eight - Place the camera

Place the Stick Up Cam where you want to mount it, rubber side down.

Step Nine - Screw in the camera

Use the three mounting screws to secure the Stick Up Cam Mount base to the ceiling.

Important: Use the enclosed drill bit to drill holes in the ceiling, then push the enclosed anchors into the holes when installing on masonry or stucco.

Step Ten - Replace the cover

Slide the back cover of the Stick Up Cam back into place. Use the star-shaped end of the screwdriver included with the Stick Up Cam to tighten the attached screw.

Step Eleven - Snap the cover onto the base 

Screw in the security screws if desired.

Last updated 2 months ago