Search Results
Showing results for install
Installing battery-powered doorbells
...mounting surface If using a Wedge Kit, Corner Kit , or mounting bracket with your device, install before mounting the doorbell. Installing on a wood surface Drill and wall anchors are not needed. Installing on a masonry surface Using the marked screw hole locations, drill pilot holes using a 6 mm...
Installing Outdoor Cam
...Cam includes a pre-installed base for placement on flat surfaces. Adjust the camera angle Rotate the base so its longer side faces forward, then tilt the camera downward. Step 4: Installing on a wall or ceiling To install on a ceiling, use the mount for Outdoor Cam. Install the mounting plate On...
Installing Indoor Cam Plus
...2. Use the mounting plate as a guide to mark screw holes on the wall. 3. Install the mounting plate with the UP arrow pointing up. On stucco, brick, or concrete, use a 3/16 in (5 mm) masonry bit to drill holes for the included...
Installing Doorbell Retrofit Kit
...5. Install the foam seal and retrofit kit over the doorbell wiring with the included screws, running the wiring through the opening. NOTE: If the retrofit kit starts to flex, the screws are too tight. 6. Clip on the retrofit cover to attach. 7. (Optional) If using a wedge or corner mount, install...
Installing your Indoor Cam (1st Gen)
...Set up and install your Indoor Cam with this step-by-step guide or view the installation guide video . Note that you should set up your Indoor Cam in the Ring app before physically installing it. 1. Set up your Indoor Cam Download the Ring app The...
Installing your Indoor Cam (2nd Gen)
...Install the mounting plate. / قم بتركيب لوحة التثبيت. Slide onto mounting plate. / أدخله في لوحة التثبيت.Adjust the camera angle. / اضبط زاوية الكاميرا...
Installing Outdoor Cam Pro Plug-In
...3. Install the mounting plate with the UP arrow pointing up. On stucco, brick, or concrete, use a 5 mm masonry bit to drill holes for the included wall...
Installing your Solar Panel (USB-C) (2nd Gen)
...This article outlines the step-by-step process to install your Solar Panel (USB-C) (2nd Gen). Setup Guide Guide de configuration Einrichtungsanleitung Guida alla configurazione Guía de instalación...
How to install your Ring Video Doorbell Pro with a hardwired transformer
...This repurposes those mains wires to carry 24 volt power to your doorbell. The final install, including the Pro Power Kit, should look similar to this diagram. 3. Install your Video Doorbell Pro Screwdriver - Use the Phillips end for the mounting screws and star-shaped end for...
Installing Stick Up Cam Pro
...Step 5: Installing the security screws Install the security screw on the battery compartment, even if you are not using batteries. Step 6: Connecting external power options Follow our guide for installing your Ring Solar Panel before connecting it to the...