Search Results
Showing results for holes
How to install your Ring Video Doorbell Pro with a hardwired transformer
...a conventional doorbell. 3.1 Uninstall your existing doorbell Unscrew your existing doorbell from the wall and disconnect its wires. 3.2 Mark the holes Using your Ring Doorbell as a template, mark the location of the two mounting holes on your wall. 3.3 Removing the faceplate To access the...
Using a Wedge Kit or Corner Kit with your doorbell
...Ring device to find the best location for your doorbell. Step 3: Marking the screw holes Use the openings on the mount to create marks for new holes. Use the two slot-shaped holes on your Wedge or Corner mount to mark where the new screw holes will be located. If you are replacing an existing...
Installing your Wired Video Doorbell Pro (formerly Video Doorbell Pro 2)
...improve motion detection and provide a better view. To skip this step, click here (set anchor) To install the Corner Mount: 1. Mark two mounting holes on your wall through the slots on your Corner Mount (fig 1) If you are replacing a Ring doorbell, align the two small screw holes with two of the...
Ring Spotlight Cam Battery Installation
...Insert the weather seal in the unused hole. Step Six - Install the mounting bracket Note that the "arm" of the mounting bracket can face either up or down, so experiment until you find what you like best. Use the bracket to mark your holes. If installing on a masonry surface like stucco...
Installing Wired Video Doorbell Pro (3rd Gen) PoE
...7/8 in) in diameter. NOTE : Exercise caution for electrical wiring and pipes when drilling. 4. Route the USB-C cable into the wall and through the hole. 5...
Installing Outdoor Cam
...into the wall. If installing on a masonry (concrete, brick, or stucco) surface, mark four screw holes using the plate as a guide. Drill pilot holes using a 0.24 in (6 mm) drill bit. Insert the included wall anchors, then drive the four mounting screws through the mounting plate into the wall...
Installing Solar Charger for battery-powered doorbells
...directly into the wall. Installing on a masonry (concrete, brick, or stucco) surface Mark four screw holes using the plate as a guide. Drill pilot holes using a 0.24 in (6 mm) drill bit. Insert the included wall anchors, then drive the four mounting screws through the Solar Charger into the wall...
Uninstalling your Door View Cam
...Replace the original peephole Replace the original peephole in the hole in the door. Use your finger to screw in the peephole clockwise as far as it will go. If you don’t have your original peephole you can pick one...
Installing and using Ring Alarm Outdoor Siren
...1: Install the mounting bracket Hold the mounting bracket at the intended installation location and level it using the bubble level. Mark your holes using the mounting bracket as a guide. Leave 2.5 cm of space around all sides for easy removal and replacement. Step 2: Drill holes Drill holes...
Installing Wedge Kit for Wired Video Doorbell Plus (2nd Gen)
...guide to prepare your install location. 2. Use the wedge mount as a guide to mark screw holes on the wall, if necessary. NOTE: Mark the both top holes or both bottom holes, depending on your desired installation location. 3. Install the mount over your doorbell wires or on the wall with the...