Search Results
Showing results for extremo-holes
Search instead for extreme-holes
Safety and compliance information for Ring Keypad (1st Generation)
...bracket on the wall, then use the wall anchors and screws from your kit to fasten the bracket to the wall (If using anchors, you should pre-drill holes). 2. Slide the Keypad onto the bracket. Screws: 3x 3x21mm. Anchors: 3x 5mm. Declaration of Conformity Hereby, Ring LLC, declares that the radio...
Installing and using Ring Alarm Outdoor Siren
...1: Install the mounting bracket Hold the mounting bracket at the intended installation location and level it using the bubble level. Mark your holes using the mounting bracket as a guide. Leave 2.5 cm of space around all sides for easy removal and replacement. Step 2: Drill holes Drill holes...
Installing your Stick Up Cam Elite
...and plug it into your Stick Up Cam. Then, hook it up with the included PoE Adapter, following this diagram. Feed an Ethernet cable through the hole in the bottom cover. Plug the other end of the cable into an Ethernet port that supplies Power over Ethernet. 3. Choose your location Stick Up Cam...
Using a Wedge Kit or Corner Kit with your doorbell
...surface Installing on a wood surface Drills and wall anchors are not needed. Installing on a masonry surface Using the marked screw hole locations, drill pilot holes using a 1/4” or 6mm drill bit. Insert the included wall anchors...
Installing Intercom Kit for Video Doorbells
...2. Remove your existing intercom. Refer to your existing intercom’s manual for uninstall instructions or consult a qualified electrician. 3. Poke holes compatible with your video doorbell...
Installing your Pan-Tilt Indoor Cam
...plate with the UP arrow pointing up. On stucco, brick, or concrete, use a 5mm (3/16 inches) masonry bit to drill holes for the included wall anchors. Run the power cable through the hole in the mounting bracket and plug in. Secure your camera to the mounting bracket by sliding until you feel a...
How to physically install your Ring Video Doorbell 3 without an existing doorbell
...of the mounting holes. If you are mounting the Ring Video Doorbell 3 on brick, concrete, or stucco, put the included plastic anchors into the holes. You may need to use a hammer to get the anchors in. If you are using the included optional adaptor mounting plate on wood or vinyl, just use the...
Set up and install Ring Intercom Audio or Ring Intercom Video
...Mark where you'll need to drill holes, and use a power drill with a 6mm drill bit. Insert wall anchors if needed. Line up your device with the holes and use the screwdriver we gave you to put in the screws...
Installing Battery Video Doorbell Plus (2nd Generation)
...as a guide to mark screw holes on the wall. 3. (Optional) If using a corner mount, install the mount on the mounting surface using the bottom holes in the top and bottom sections, ensuring it is facing in your desired viewing direction. On stucco, brick, or concrete, use a 1/4 in (6 mm...
Hardwired Kit for Cameras Installation Guide
...fastener screws. WARNING: The pressing plate should be over the cable insulation, and not over the individual wires. 4. Use level and mark screw holes. 5. Install junction box. 6. Cover screws with rubber caps...