Search Results
Showing results for -install
Installing and using Ring Alarm Outdoor Contact Sensor
...Installing your Outdoor Contact Sensor The Outdoor Contact Sensor has two parts; the slimmer part is the magnet, and the larger part is the sensor. Install the magnet to the door or window itself, and install the sensor to the door frame or window frame. Get tips on installing your...
Installing your Stick Up Cam Battery (2nd Gen)
...a shelf or table Place the rubber pad on the bottom of the base. Snap the cover onto the base. Place your Stick Up Cam on a table or shelf. Installing Stick Up Cam on a wall or ceiling If you're mounting Stick Up Cam on a wall: Push the rubber pad into the top of the base. Flip the...
Installing Spotlight Cam Pro (2nd Gen) PoE
...Align the hex joint with the junction box cover mount and insert. 18. Turn until your camera locks in place. 19. Tighten the security screw. 20. Install your camera’s decorative cover by sliding until you hear a click to secure. 21. Adjust your camera’s position, if necessary. 22. Apply proper...
Installing Battery Video Doorbell Plus (2nd Generation)
...bit to drill holes for the included wall anchors. 4. (Optional) If installing multiple wedge or corner mounts, insert screws through both mounts to hold them together. NOTE: We do not recommend more than two. 5. Install the mounting bracket on your mount or directly on the mounting surface...
Installing Hardwired Kit for Outdoor Cam Pro and Spotlight Cam Pro (2nd Gen)
...electrical work; permits and/or professional installation may be required by law. CAUTION: Risk of fire. Do not install near combustible or flammable surfaces. The Hardwired Kit must be installed on a wall or eave. Before you begin installing your Hardwired Kit, make sure that you’re...
Installing your Hardwired Kit for Spotlight Cam Wired/Mount
...3. Cut the grommet The included backbox has two cable inlets with rubber grommets. Choose the inlet that suits your install location, then get out the scissors. Cut off the end of the grommet cone at a point where it’s a bit narrower than your cable. If you’re routing...
Installing DIN Rail Transformer (2nd Gen and 3rd Gen)
...dörrklockan för att slutföra installationen. Follow these step-by-step instructions to install your DIN Rail Transformer (2nd Gen and 3rd Gen). Hardware Included Tools Needed Phillips-head screwdriver Installation 1. Shut off power at the breaker. NOTE: If you are unsure which breaker to flip, turn...
Installing Wedge Kit for Wired Video Doorbell Pro (3rd Gen)
...on your desired installation location. 3. Install the mount over your doorbell wires or on the wall with the included screws, ensuring it is facing down. On stucco, brick, or concrete, use a 6 mm masonry bit to drill holes for the included wall anchors. 4. If installing multiple wedge or...
Installing Wired Video Doorbell Pro (3rd Gen) PoE
...a 6 mm (1/4 in) masonry bit to drill holes for the included wall anchors. 7. (Optional) If installing multiple wedge or corner mounts, insert screws through both mounts to hold them together. 8. Install the mounting bracket on your mount or directly over the spacer with the included screws. 9...
Installing No-Drill Mount (2nd Gen) for Battery Video Doorbell (2nd Gen) devices
...five minutes and allow an hour for it to adhere. 4. Attach the Wedge or Corner Kit using the two included bracket screws. Important note : If installing on a Wedge Kit, insert screw into a threaded hole on either side of the bottom opening...