Search Results
Showing results for screws
Using the adapter plate included with your Ring Video Doorbell 2
...holes You can line up the holes in the adapter plate with the holes left behind from your original Ring mounting bracket. Then use the install screws to attach the adapter plate to the wall. 3. Pull the existing doorbell wires through the middle of the adapter alate Note that this step is only...
Installing Wired Video Doorbell Pro (3rd Gen) PoE
...Optional) If using a wedge mount, install the mount over the USB-C cable using the screws included with your wedge kit, ensuring it is facing down. On stucco, brick, or concrete, use a 6 mm (1/4 in) masonry bit to drill holes for the...
Installing your Indoor Cam (1st Gen)
...Screw it into the back of your Indoor Cam with the “UP” arrow on the bracket pointing upwards. Remove the mounting bracket Slide it down. It’ll come right off the base. Drive the screws Hold the plate against your wall, making sure the “UP” arrow is pointing up, and mount it with the included screws...
Installing Intercom Kit for Video Doorbells
...القطع المزودة Screw #1 Length: 30.25mm Screw Head Diameter: 5mm Screw #2 Length: 10mm Screw Head Diameter: 5.85mm Screw #3 Length: 13.75mm Screw Head Diameter: 4.85mm Intercom Kit for Video Doorbells | 2 1. Warning: Professional installation recommended. Turn off the power to your existing...
Installing lens cover for Outdoor Cam Pro
...of your camera to secure. 6. Attach the screw cap to the bottom of your camera. 7. Attach the camera mount to the back of your camera with its screw. 8. Reattach the mounting plate by sliding until you hear a click to secure. 9. Refer to your camera setup guide to attach your camera to the wall...
Installing Pole and Wall Mount for Cameras and Solar Panels
...the back of your security camera and use it to plug the bottom. 6. Attach the security camera mount to the back of your security camera with its screw. 7. Clasp the security camera mount and attach your security camera to the mounting plate by sliding until you feel a click. 8. Unclasp the...
Installing Spotlight Cam Pro (2nd Gen) Plug-In
...plate by sliding until you feel a click. NOTE: Your camera should be in an upright position. 7. Rotate your camera and tighten the security screw. 8. Adjust your camera’s position and tighten the ball joint to secure in place. 9. Plug the power cable in until the indicator line disappears...
Safety and compliance information for Ring Keypad (1st Generation)
...1. Place the mounting bracket on the wall, then use the wall anchors and screws from your kit to fasten the bracket to the wall (If using anchors, you should pre-drill holes). 2. Slide the Keypad onto the bracket. Screws: 3x 3x21mm. Anchors: 3x 5mm. Declaration of Conformity Hereby, Ring LLC...
Installing Spotlight Cam (2nd Generation)
...with its screw. 6. Secure your camera to the mounting plate by sliding until you feel a click. 7 . Rotate your camera and tighten the security screw. 8 . Adjust your camera's position and tighten the ball joint to secure in place. Ceiling installation 1. Slide the mounting plate in the...
Installing Spotlight Cam Pro (2nd Gen) PoE
...is fully inserted. 9. Slot the adapter into the centre of the junction box. 10. Attach the metal crossbar with the screws included with your adapter, starting with the closed screw hole. 11. Close the junction box with the cover mount. 12. Tighten the centre screw to secure the junction box cover...