Search Results
Showing results for holes
Set up and install Ring Intercom Audio or Ring Intercom Video
...Mark where you'll need to drill holes, and use a power drill with a 6mm drill bit. Insert wall anchors if needed. Line up your device with the holes and use the screwdriver we gave you to put in the screws...
Installing Spotlight Cam Plus or Pro
...on a wood surface : Screw the plate directly into the wall. If installing on a masonry (concrete, brick, or stucco) surface: Mark four screw holes using the plate as a guide. Drill pilot holes using a 6 mm drill bit. Insert the included wall anchors, then drive the four mounting screws...
Installing your Stick Up Cam Elite
...and plug it into your Stick Up Cam. Then, hook it up with the included PoE Adapter, following this diagram. Feed an Ethernet cable through the hole in the bottom cover. Plug the other end of the cable into an Ethernet port that supplies Power over Ethernet. 3. Choose your location Stick Up Cam...
Installing Wired Video Doorbell Plus (2nd Gen) Plug-In
...electrical wiring and pipes when drilling. 3. (Optional) If using a corner mount, install the mount over your doorbell wires using the large oval holes, ensuring it is facing in your desired viewing direction. NOTE: Multiple corner mounts can be stacked together. We do not recommend more than two...
Installing Wired Video Doorbell Pro (3rd Gen) Plug-In
...for electrical wiring and pipes when drilling. 3. (Optional) If using a corner mount, install the mount over your doorbell wires using the bottom holes in the top and bottom sections, ensuring it is facing in your desired viewing direction. NOTE: Multiple corner mounts can be stacked together. We...
Installing Floodlight Cam Wired Plus and Pro
...mounting plate as a template. Then, use a 6mm masonry drill bit (not included) to drill holes in the wall, and insert the included anchors. 7. Install the mounting plate Run the wires through the hole in the mounting plate. Install the mounting plate with the two posts level with the ground...
Safety and compliance information for Ring Keypad (1st Generation)
...bracket on the wall, then use the wall anchors and screws from your kit to fasten the bracket to the wall (If using anchors, you should pre-drill holes). 2. Slide the Keypad onto the bracket. Screws: 3x 3x21mm. Anchors: 3x 5mm. Declaration of Conformity Hereby, Ring LLC, declares that the radio...
Installing your hardwired transformer kit
...Firmly insert the doorbell wires into the ‘Bypass Mode’ holes on the Pro Power Kit V2 until they lock into place. Replace the cover on your doorbell. Turn the power back on at the source. In the Ring app...
Installing Ring Alarm at your business
...used to gain access to your business. If installing Contact Sensors on warehouse doors or metal door and window casings, you may need to pre-drill holes and get special screws designed for this type of installation...
Installing Floodlight Cam Wired Pro (2nd Gen)
...2. On stucco, brick, or concrete, use a 6 mm masonry bit to drill holes for the included wall anchors. Floodlight Cam Pro (2nd Gen) | 7EN 3. Feed the wires through the mounting plate. 4. Install the mounting plate with...