Search Results
Showing results for holes-from'
Installing Outdoor Cam
...into the wall. If installing on a masonry (concrete, brick, or stucco) surface, mark four screw holes using the plate as a guide. Drill pilot holes using a 0.24 in (6 mm) drill bit. Insert the included wall anchors, then drive the four mounting screws through the mounting plate into the wall...
Uninstalling your Door View Cam
...Replace the original peephole Replace the original peephole in the hole in the door. Use your finger to screw in the peephole clockwise as far as it will go. If you don’t have your original peephole you can pick one...
How to install your Ring Video Doorbell Pro with a hardwired transformer
...a conventional doorbell. 3.1 Uninstall your existing doorbell Unscrew your existing doorbell from the wall and disconnect its wires. 3.2 Mark the holes Using your Ring Doorbell as a template, mark the location of the two mounting holes on your wall. 3.3 Removing the faceplate To access the...
Using a Wedge Kit or Corner Kit with your doorbell
...surface Installing on a wood surface Drills and wall anchors are not needed. Installing on a masonry surface Using the marked screw hole locations, drill pilot holes using a 1/4” or 6mm drill bit. Insert the included wall anchors...
Installing your Door View Cam
...it one day. Smooth out the hole’s edges with the tool. 5. Place the outdoor assembly. From the front side of your door, insert the tube through the hole until your Door View Cam is flush with the door. Once inserted, go inside and remove the cap from the end of the tube, if present. 6. Check to see...
Installing your hardwired transformer kit
...Firmly insert the doorbell wires into the ‘Bypass Mode’ holes on the Pro Power Kit V2 until they lock into place. Replace the cover on your doorbell. Turn the power back on at the source. In the Ring app...
Installing your Wired Video Doorbell Pro (formerly Video Doorbell Pro 2)
...improve motion detection and provide a better view. To skip this step, click here (set anchor) To install the Corner Mount: 1. Mark two mounting holes on your wall through the slots on your Corner Mount (fig 1) If you are replacing a Ring doorbell, align the two small screw holes with two of the...
Installing Video Doorbell Pro Retrofit Kit
...with a Ring Video Doorbell Pro using the Retrofit Kit: Uninstall your existing Ring Video Doorbell. Place the Retrofit Kit on the mounting holes that were used for your previous Ring Video Doorbell installation. Place the Ring Video Doorbell Pro over the Retrofit Kit. Make sure that the...
Installing PoE+ Converter Mount
...Slide the mounting plate on your camera’s native mount opposite to the UP arrow to remove. 2. Use the mounting plate to mark screw holes on the wall. 3. Route the Ethernet cable. Routing the cable through the wall: 3a. Feed the Ethernet cable through the included grommet, then the...
Installing Ring Video Doorbell Wired
...two mounting holes on your wall. 10. Install the anchors from Bag A (optional) On stucco, brick or concrete, use a 1/4" (6mm) masonry bit to drill holes in your wall, then insert the included wall anchors. Note : If you're installing on wood or siding, you can skip this step. 11. Connect the...