Installing Ring Floodlight Cam 4K Plus

Safety and compliance information for Ring Floodlight Cam 4K Plus.

Hardware included

Tools needed

• Screwdriver

Safety warnings

WARNING: Risk of electrical shock. Disconnect power at the fuse or circuit breaker before installing.

CAUTION: Risk of fire. Do not install near combustible or flammable surfaces.

Note: The Floodlight Cam must be installed on a 4-inch round UL-listed weatherproof electrical box.

This manual is for informational purposes only. Working with electricity can be dangerous unless proper safety precautions are taken. If the neighbor is not comfortable or is inexperienced with the processes and tools described in this manual, it is recommended that a licensed electrician be hired.

Getting started

1. Download the Ring app.
   
2. Scan the QR code on the device.
   
3. Shut off power at the consumer unit.
   
   Note:

   If unsure which breaker to flip, the master breaker should be turned off or a licensed electrician should be contacted.
4. Verify that the supply voltage is correct. Connect the fixture to a 100 to 240 VAC 50/60Hz power source.

Important note: Do not connect this light fixture to a dimmer switch or timer.

Wall installation

1. Remove the existing floodlight and disconnect the wires.
   
   On stucco, brick, or concrete, use a 6 mm masonry bit to drill holes for the included wall anchors.
   
2. Feed the wires through the mounting plate.
   
3. Install the mounting plate with the UP arrow pointing up.

   Note:

   Use the included screwdriver, washers, and screws.
   
4. Attach the pressing plate over the wire insulation and not over the individual wires.

   CAUTION:

   Risk of fire. Follow the standard electrical code in the applicable country. A qualified electrician should be consulted if there is uncertainty or discomfort in performing the installation.
   
5. Use the nylon strap on the back of the camera fixture to hook it onto the mounting plate.

   Note:

   Ensure the buckle and hook are secure before releasing.
   
6. Connect the wires from the camera to the terminal block.

   Note:

   Gently tug on the wires to ensure they are securely connected. Properly ground the fixture. Always follow code standards when installing wired connections.
   
7. Route the wires from the camera fixture along the right side of the mounting plate.
   
8. Slide the camera fixture onto the mounting plate and attach using the included hex nuts.
   
9. Rotate the lights out of the way, then rotate the camera clockwise.
   
10. Remove the shank from the included screwdriver and use the handle to tighten the hex nuts. Then, cover with the included hex nut caps.
    
11. Apply a weatherproof silicone caulk or sealant around the perimeter of the lighting fixture to seal any gaps between the lighting fixture and the mounting surface.
    
12. Restore power at the consumer unit.