Safety and compliance information for Ring Motion Detector (1st Generation)
Use responsibly. Read all instructions and safety information before use.
Safety Information
WARNING: Failure to read and follow these safety instructions before operation could result in fire, electric shock, or other injury or damage.
WARNING: Your device should only be used in accordance with the specific instructions for use and intended purpose of the device. Using your device in any way other than its intended purpose could cause injury to yourself, others and/or damage to the device or property.
CAUTION: The device is not waterproof and as such should not be submerged in water, doing so could cause injury to yourself, others and/or damage to the device.
WATCH FOR SMALL PARTS. Your device and accessories may present a choking hazard to small children. Keep them out of reach of small children.
Battery Safety
This product contains a lithium metal battery. This device requires batteries for use. Only use new CR123A 3V batteries. Keep all of the batteries out of the reach of children. Do not open, disassemble, puncture, cut, bend, shred or heat the batteries and do not allow metal objects to touch the battery terminals on the device as they can become hot and cause burns. Remove all batteries if they are worn out or before storing your Device for an extended period of time. Dispose of all batteries in accordance with applicable laws and regulations and do not dispose of batteries by throwing them into a fire. If any batteries begin to leak, take steps to prevent the fluid from coming into direct contact with skin or clothes as the fluid could be corrosive and may be toxic. Remove the batteries and clean the battery compartment in accordance with the battery manufacturer’s recommendations.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of the used batteries according to the manufacturer’s instructions.
Product Specifications
Model Number: 4SPAE9-0EU0
Electrical Rating: 1x CR123A 3V
Temperature Rating: 0°C - 49°C
Declaration of Conformity
Hereby, Ring LLC, declares that the radio equipment Ring Motion Detector (4SPAE9-0EU0) is in compliance with Directive 2014/53/EU and UK Radio Equipment Regulation, RER 2017 (S.I. 2017/1206), including currently valid amendment(s). The full texts of the declarations of conformity and other applicable statements of compliance for this product are available at the following internet address: www.ring.com/DoC
Wireless Features: Z-Wave
Maximum Radio Frequency Power:
868.4 - 869.85 MHz 13.85 dBm EIRP
Radio Frequency Compliance
In order to protect human health, Ring Motion Detector meets the thresholds for exposure of the general public to electromagnetic fields according to Council Recommendation 1999/519/EC. Ring Motion Detector should be installed and operated with at least 20 cm between the radiator and your body. For Z-Wave technical information, visit ring.com/z-wave.
Recycling Your Device Properly
In some areas, the disposal of certain electronic devices is regulated. Make sure you dispose of, or recycle, your device in accordance with your local laws and regulations. For information about recycling your device, go to www.amazon.com/devicesupport.