Installing Spotlight Cam (2nd Generation) Battery

Hardware included

Tools needed

Phillips-head screwdriver

Drill with 6 mm masonry bit (optional)

1. Twist the battery cover counterclockwise to open the battery cover.

2. Click the ejector button to eject the battery housing.

3. Push the tab to remove the battery.

4. Discard the battery insulator and fully charge the battery.

5. Insert the battery and twist to close the battery cover to the locked position.

6. Tighten the security screw on the battery cover.

CAUTION! The security screw creates a seal to prevent damage from rain or humidity. Always tighten it when replacing the battery.

7. Download the Ring Always Home app.

8. Scan the QR code on your device

9. Choose a location.

Wall installation

1. Slide the mounting plate in the direction opposite to the UP arrow to remove.

2. Use the mounting plate as a guide to mark screw holes on the wall with 14 cm of space in every direction.

3. Install the mounting plate with the UP arrow pointing up.

On stucco, brick, or concrete, use a 1/4 in (6 mm) masonry bit to drill holes for the included wall anchors.

4. Remove the middle rubber cap on the back of your camera.

5. Attach the camera mount to the back of your camera with its screw.

6. Secure your camera to the mounting plate by sliding until you feel a click.

7. Rotate your camera and tighten the security screw.

8. Adjust your camera’s position and tighten the ball joint to secure in place.

Ceiling installation

1. Slide the mounting plate in the direction opposite to the UP arrow to remove.

2. Use the mounting plate as a guide to mark screw holes on the ceiling with 14 cm of space in every direction.

NOTE: For best results, avoid locations with nearby objects that can interfere with your camera’s field of view.

3. Install the mounting plate with the UP arrow pointing toward your desired viewing direction.

On stucco, brick, or concrete, use a 1/4 in (6 mm) masonry bit to drill holes for the included wall anchors.

4. Remove the top rubber cap on the back of your camera.

5. Attach the camera mount to the back of your camera with its screw.

6. Secure your camera to the mounting plate by sliding until you feel a click.

NOTE: Your camera should be in an upright position.

7. Rotate your camera and tighten the security screw.

8. Adjust your camera’s position and tighten the ball joint to secure in place